I used veins-4a2. Yesterday, when I launched the simulation as usual my map is not displayed correctly (in the gray area).
What should I do to correct the map display please? Here attached the map display
Asked
Active
Viewed 332 times
1 Answers
0
The gray area is a module representation by OMNeT++. The OMNeT++ manual has a whole chapter describing how to modify these settings.
In your simulation you have to modify the pparameter to some smaller values that it does not show up so big in your map.
floxyz
- 686
- 4
- 9
-
Thank you for your response Sir. – Myriam May 25 '16 at 08:15